Horizon Fitness QC-S30 Important Information Manual page 36

Maintenance: Feed Rollers
Front Side of Machine
Marks on
the side
of the roller
31
c
!
1
Roller Shaft
2
Rear Side
Feed Roller
1
Marks
2
U-shaped Cutout
Projection
Replacing a Feed Roller
Turn off the main power switch and unplug
the power cord whenever the feed roller is
cleaned or replaced.
Turn off the power switch.
• Turn off the main power switch for the QC-S30 and
unplug the power cord.
21098
40201A1
Remove the roller shaft.
• Pull the shaft and feed roller toward the near side of
the machine.
• Pull out the right end of the shaft.
21098
40201B1
Replace the feed roller.
• When installing the new feed roller on the roller
shaft, face the marks on the side of the roller toward
the rear of the machine. Lock the feed roller against
the flange of the wheel.
Important
• If the feed roller is installed in the wrong direction,
misfeeding may occur.
21098
40201E1
Install the roller shaft.
• When re-assembling, insert the projection on the
roller shaft to the U-shaped cutout on the fixed end
of the shaft.
21098
40201D1
WARNING