Trouble; Poor Arrangement Of Sheets - Horizon Fitness QC-S30 Important Information Manual

Trouble: Poor Arrangement of Sheets

Poor Arrangement of Sheets

Check
The sheets in the bins
are not stacked cor-
rectly.
Check whether the
sheets are bent or
curled.
Check whether the sheet
is stuck on the support
roller.
Check whether the
sheets in the bin are
higher 28 mm (1.1").
Check whether the front
guide is set against the
edge of the stack too
tightly, or too loosely.
Check whether the
sheets are held together
by static electricity.
Check whether the col-
lated sets are leaning to
either side on the receiv-
ing tray.
Poor Arrangement of Offset
Check whether the offset
sets are leaning to either
side on the receiving
tray.
27
Causes and Remedies
Fan and stack the sheets correctly before load-
ing them into the bins.
21098
40103D1
Check the sheets in the bins and remove any
sheets which are bent or curled.
21098
40106A1
Check the bins and remove any sheet which is
Support
stuck on the support roller.
Roller
21098
40103C1
Do not load sheets in the bin higher than 28
28 mm (1.1")
mm (1.1").
21098
40102E1
If the front guide is set too tight, set the
guide so that it just touches the edge of the
stack. If the front guide is set too loose, posi-
tion the front guide up against the stack
without any gap.
21098
40102A1
Reset the backstop 10 to 20 mm (0.4" to
0.8") away from the edge of the stack.
10 mm (0.4")
to 20 mm (0.8")
21098
40106B1
Move the backstop to the side where the
Receiving
sheets are leaning. (The back stop is set at
Tray
the middle normally.)
21098
40106C1
Move the backstop to the side where the
Receiving
sheets are leaning. (The back stop is set at
Tray
the middle normally.)
21098
40106C1
Page
Page 5
-
-
-
Page 5
Page 7,8
-
-