Horizon Fitness QC-S30 Important Information Manual page 11

Additional Information: Sheet Loading Direction
Feed From Short Edge
A5 (5.5" x 8.5")
A4 (8.5" x 11")
8.5" x 14"
A3 (11" x 17")
Bin Support
Pull this out to support the sheets.
Additional Information: Sheet Transport Direction
Collator Only
Last (10th)
9th
8th
7th
6th
5th
4th
3rd
2nd
Top (1st)
Collated Set
With SPF9/9A or MF-1
Feed
Top (1st)
2nd
Last (10th)
Collated Set
Feed From Long Edge
A4 (8.5" x 11")
Support
Stopper
21098
20101E1
21098
20101F1
Feed
Top (1st)
2nd
Last (10th)
21098
20101G1
Top (1st)
2nd
3rd
4th
5th
6th
7th
8th
9th
Last (10th)
21098
20101H1
Usually, load the sheets so they feed from the
short edge.
• A4 (8.5" x 11") size sheets can be collated as shown in
the right-hand illustration. Use the support stopper on
the receiving tray.
• Avoid feeding A5 sheets (5.5" x 8.5") from the long
edge. This can cause double-feeding.
When using A3 (11" x 17") size sheets:
• Pull out the bin supports.
When using the collator without SPF-9/9A or MF-1:
• The collated sets are delivered to the right.
1) Load the sheets in the bins face down.
2) Load the first sheets in the bottom bin, and the rest of
the sheets above that in order.
When using the collator with SPF-9/9A or MF-1:
• The collated sets are delivered to the left.
1) Load the sheets in the bins face up.
2) Load the first sheets in the top bin, and the rest of the
sheets below that in order.
• When three collators are connected, sheets cannot be
transported from the rightmost collator to the finisher.
6