Otto Bock 10V39 Instructions For Use Manual page 15

poses, drivers should have their driving ability examined and approved by
an authorized test center. For maximum safety and convenience, Ottobock
recommends that, at the very least, a specialist evaluate the need for any
adaptations to the car (such as by installing a steering fork).
Caution!
Before starting the car, check the 10V39=* MovoWrist Flex for
proper lock and secure seat.
6 Function
The 10V39=* MovoWrist Flex (fig. 1, item 2) allows for a fitting in conjunc-
tion with an Ottobock system hand or Ottobock cable-activated hook or
another teminal device.
It features flexion and extension settings in different positions. This joint is
also rotatable on the forearm socket in steps of 18°. To allow for an easy
change of the terminal devices in every position, the 10V39=* MovoWrist
Flex is equipped with a quick-release lock.
Three push-buttons are assigned to different functions (fig. 3). These are
used for setting the rotation (1), exchanging system hands or a cable-
activated hook (2) as well as for flexion and extension (3).
The wrist unit is available in two sizes and can be used on both sides:
10V39=45 for forearm socket with inner diameter for wrist unit connec-
tion of 45 mm
10V39=50 for forearm socket with inner diameter for wrist unit connec-
tion of 50mm
6.1 Rotation
The 10V39=* MovoWrist Flex unlocks for rotation by pressing the push button
1 (fig. 3). It can be freely positioned in 20 different engaging points. When
the push button 1 is released in an engaging position, the wrist unit will lock.
6.2 Exchange
The push button 2 (fig. 3) unlocks the wrist unit for exchange of the sys-
tem hands, cable-activated hook or terminal device. The system hand,
hook or terminal device ejection is supported by a spring integrated in the
10A30=* Adapter.
Ottobock | 15