Selecting The Input Source - Tascam DV-RA1000HD Owner's Manual

Selecting the input source

The input source for recording can be selected as
described here:
1
Press the key, and use the
MENU
to select SYSTEM SETUP . Press
2
Use the dial to select
JOG/DATA
.
ENTER
3
Use the dial to select from the follow-
JOG/DATA
ing screen:
Figure 4.17: Selecting the input source
4
First, choose between
on the INPUT
DIGITAL
If you choose the analog option, remember that
both the balanced XLR inputs and the unbal-
anced RCA inputs are active together, but you
should only use one set.
5
If you are recording to CD, or a 44.1/48 kHz or
88.2/96 kHz-sampling frequency PCM DVD and
HD, select the DIO parameter (digital I/O) as ei-
ther or
AES/EBU
appropriate digital terminals will also be used for
output of the digital signal.
CD-R/RW
COAXIAL / AES/EBU COAXIAL / AES/EBU COAXIAL / AES/EBU AES/EBU only
DIO
n/a
MODE
The selected input is shown on the home display.
dial
JOG/DATA
.
ENTER
. Press
I/O SELECT
and
ANALOG
parameter.
(S/PDIF). The
COAXIAL
44.1/48 kHz
Sampling frequen-
cy DVD/HD
n/a
Table 4.18: Digital input source options
4 − Basic operations
If you are recording to a 176.4/192 kHz-sampling
frequency DVD and HD, this option is not avail-
able, and
AES/EBU
If you are recording to a DSD DVD and HD, the
signals will always be input and output through
the BNC connectors. The
chooses the format in which the audio is sent and
received:
DSD-RAW
stream, or
SDIF-3
able). Consult the documentation for your other
equipment to find out what format is most suit-
able for your setup.
6
Finally, in the case of 88.2/96 kHz-sampling fre-
quency DVD and HD with
as the input/output connector, there is an option
to select double-wire or double-speed as the I/O
format ( ).
MODE
The
COAXIAL
mode only, and 176.4/192 kHz-sampling fre-
quency is double-speed + double-wire mode, and
cannot be changed.
7
Press to confirm your settings and return
ENTER
to the system setup menu.
TIP
The DV-RA1000HD is not equipped with a sampling
rate converter.
If you set the INPUT parameter to
put a signal with a sampling frequency of .1 kHz
for CD recording. For DVD±RW or HD recording in
PCM mode, input a signal with the same sampling
frequency as that for the project.
88.2/96 kHz 176.4/192 kHz
Sampling frequen- Sampling frequen-
cy DVD/HD cy DVD/HD
COAXIAL – Double-speed +
double-speed only double-wire only
AES/EBU –
double-wire or
double-speed
is the only option available.
parameter here
DIO
, which is the raw DSD bit
(no other options are avail-
selected
AES/EBU
option allows double-speed
, in-
DIGITAL
DSD DVD/HD
SDIF-3 or RAW DSD
n/a

TASCAM DV-RA1000HD