Fades Dvd Hd; Timer Start Dvd Hd; Recording; Basic Recording Operation - Tascam DV-RA1000HD Owner's Manual

Fades
DVD HD
It is possible to create linear fades in and out when
playing back.
To display the fade time screen, press for at least one
second the switch on the play page of the virtual
FADE
front panel, or the key on the remote control unit.
FADE
Use the and cursor keys and the
F1 F2
to set these values (between 0 seconds and 24 seconds).
Fade times are set independently for fade-in and fade-
out operations.
Press to confirm the fade time settings.
ENTER
Timer start
DVD HD
The switch besides the transport keys on the
TIMER
front panel allows the DV-RA1000HD to start playback
of the loaded disc automatically when power is sup-
plied.
If the DV-RA1000HD is in ODD mode or in HDD
mode with a disc already loaded, the unit plays the proj-
ect that was open prior to the last shut down, or from
the last position if resume playback is selected. (See
"Resume playback" on page 24.)

Recording

The following functions are available when recording to
CD-R or CD-RW. Many are also available when record-
ing to DVD±RW or HD.

Basic recording operation

The transport keys enable you to record discs as if you
were using a standard recorder.
1
Press the key (
RECORD
port section is stopped or playback is paused to
place the DV-RA1000HD in record ready mode.
The key and
RECORD
up.
The DV-RA1000HD switches monitoring mode
to input signal.
• When you insert a brand new disc into the
disc tray and press the
DV-RA1000HD automatically performs opti-
cal power calibration (OPC). During the cal-
ibration, the
RECORD
and the key indicator flashes. When
READY
5 − CD playback & recording
dial
JOG/DATA
DVD±RW HD
key) while the trans-
REC
key indicators light
READY
key, the
RECORD
key indicator lights up
Figure 5.3: Setting fade times
• When playback starts and fade mode is
selected, a fade-in starts.
• When playback stops (with the
and fade mode is selected, the fade-out
starts. If the
STOP
fade, playback stops immediately.
Repeat settings (see "Repeat playback" on page 31) for
the whole disc or single track are memorized when the
power is turned off and on again, but the A-B mode and
the A and B points are not memorized.
CAUTION
When using this function, remember to shut down
the unit properly (see "Shut down" on page 1)
before turning off the power, to avoid possible data
loss.
the calibration is complete, the
indicator lights up and the unit enters record
ready mode.
NOTE
Optical power calibration adjusts the laser power in
accordance with the characteristics of an inserted
disc so that data can be recorded at optimum qual-
ity.
2
Press the key to start recording.
PLAY
The key and
RECORD
up.
• To stop recording, press the
• To mute recording (that is, recording a silent
part), press the
MUTE
key briefly to mute recording. Press the
key)
STOP
key is pressed during the
key
READY
key indicators light
PLAY
key.
STOP
key. Press the
MUTE

TASCAM DV-RA1000HD