Adjusting The Input Level; Selecting The Reference Clock - Tascam DV-RA1000HD Owner's Manual
High definition audio master recorder
Hide thumbs
Also See for DV-RA1000HD:
- Specification (27 pages) ,
- Technical documentation (4 pages) ,
- Supplemental manual (2 pages)
Table of Contents
Advertisement
4 − Basic operations
Adjusting the input level
The input level is adjustable for all inputs (analog or
digital), regardless of the current selection.
The balance between the left and right channels of the
input may also be set.
For optimum sonic quality, it is also possible to bypass
the input level and balance circuitry.
1
Press the
INPUT LEVEL
level screen:
Figure 4.19: Input level settings
Selecting the reference clock
As mentioned earlier, only one clock sync source
should be available within a system.
The current clock selection is always shown on the
home display.
To select the clock source for the DV-RA1000HD:
1
Press the
key, and use the
MENU
to select
SYSTEM SETUP
. Press
2
Use the
dial to select
JOG/DATA
Press
.
ENTER
Figure 4.20: Word sync selection
TASCAM DV-RA1000HD
key to bring up the input
dial
JOG/DATA
.
ENTER
.
REFERENCE CLOCK
2
Use the
and
keys to move between the
F3
F4
(input level),
BALANCE
(between left and right) and
BYPASS
sections of the display.
Use the
dial to adjust the settings,
JOG/DATA
including the bypass setting.
TIP
•
Use the
key to reset the input level to unity
F1
gain, and the
key to center the balance set-
F2
ting.
•
You can adjust the analog input level to one of
the stages in the range of –∞ through +1 dB,
and the digital input level in steps of 0. dB in the
range of –10 dB through +10 dB.
3
Press
when finished.
ENTER
NOTE
•
When the signal on playback or recording is at –
0.1 dBFS or over for more than one sample, the
OVER indicator on the meter lights. If a track is
normalized to –0.1 dB (for example) on a DAW be-
fore recording at unity gain on the DV-RA1000HD,
the OVER indicators may therefore light, even
though there is no clipping taking place.
•
You can set the meter release time and peak hold
mode in the preference screen. (See "General
preferences" on page .)
To reset the peak indication, press the
key while the home screen is displayed.
3
Use the
dial to select the clock source
JOG/DATA
(
SOURCE
):
•
—the DV-RA1000HD acts as the
Internal
clock master.
•
—the clock sync is received from the BNC
Word
connector.
WORD SYNC IN
•
—the clock is received from the
Digital IN
currently selected digital audio input source.
NOTE
You cannot select
Digital IN
DV-RA1000HD is playing or recording a project in
DSD mode.
4
Press
to confirm the setting and return to
ENTER
the system setup menu.
MAIN
CANCEL
if the
Advertisement
Table of Contents
