Installation - ADJ MOD STQ User Instructions

MOD STQ
When installing the unit, the trussing or area of installation must be able to hold 10 times the weight
without any deformation. When installing the unit must be secured with a secondary safety attachment,
e.g. and appropriate safety cable. Never stand directly below the unit when mounting, removing, or
servicing the unit.
Overhead mounting requires extensive experience, including calculating working load limits, installation
material being used, and perodic safety inspection of all installation material and unit. If you lack
these qualifications, do not attempt the installation yourself.
These installaiton should be checked by a skilled person once a year.
NOTICE: The suitable enviromental temperature for this lighting fixture is between -25˚ C to 45˚ C.
Do not place this lighting fixture in an enviroment where the temperatures are under or above the
temperatures stated above. This will allow the fixture to run at its best and help prolong the fixture
life.
Screw one clamp via a M12 screw and nut into the bracket. Pull a safety cable through the opening(s)
located on either side of the bracket and over the trussing system or a safe fixation spot. Insert the
end in the carabine and tighten the safety screw.
The MOD STQ is fully operational in three different mounting positions, hanging upside-down from a
ceiling or trussing, sideways on trussing, or set on a flat level surface. Be sure this fixture is kept at
least 12m (40ft) away from any flammable materials (decoration etc.). Always use and install the supplied
safety cable as a safety measure to prevent accidental damage and/or injury in the event the clamp
fails (see next page). Never use the carrying handles for secondary attachment.
ADJ Products, LLC - www.adj.com - MOD STQ User Manual Page 7
CLAMP
(NOT INCLUDED)

Installation