Return To Home; Using The Return To Home Button On The Controller; Return To Home Button Cancellation - XDynamics EVOLVE User Manual

USING THE RETURN TO HOME BUTTON ON THE CONTROLLER

Follow the steps below:
1. Make sure GPS Signal is showing at least 'Good' (if not, visually track the aircraft as it flies back to home position).
2. Press and hold the Return to Home button for 3 seconds.
3. The aircraft will ascend to a pre-set altitude, or if at a greater altitude than the programed altitude it will remain at that
altitude, and then return to the Home Point in shortest path (straight line).
4. Smart Pilot System indicates the aircraft is under Return to Home Mode.
5. When reaching the home point the aircraft will hover for few seconds then proceed to auto land (during the descent
the operator can reposition the aircraft to clear away from obstacles or land in preferred spot).
Press and hold the Return to Home button for 3 seconds
68
Return to home successful
Return to home failed

RETURN TO HOME BUTTON CANCELLATION

During the return home flight the user may stop the Return to Home process by following the steps below
1. Press the cancel button to stop the Return to Home process.
2.
The aircraft will continue in the mode at which the 3 position switch mode is selected.
Press the Cancel Button
to stop the Return to Home process
Evolve User Manual V1.0 by XDynamics Limited 69