Settings Menu; Linking The Remote Controller - XDynamics EVOLVE User Manual

SETTINGS MENU

The settings menu allows the operator to configure the aircraft to suit their preferences. Settings include aircraft,
Controller, Battery, Gimbal, Map and General.
Aircraft Settings Controller Settings
Gimbal Settings Map Settings
42
Battery Settings
General Settings

LINKING THE REMOTE CONTROLLER

The Evolve aircraft system is pre linked from the factory. If there's a situation which requires the Ground Station and the
aircraft to be re-linked follow the steps below:
To pair the Ground Station to a new aircraft follow these steps:
1. Navigate to the Smart Pilot System aircraft Pairing Page.
2. Turn on the aircraft.
3. Keep the aircraft at least 3ft away from the remote controller.
4. Tap "Start Pairing" on the Ground Station screen.
5. Follow the instructions on screen to complete the pairing.
6. The screen shows the modules pairing status.
7. The whole pairing process may take up to 1 minute.
Only required if pilot is trying to pair a new aircraft to the Ground Station or a new controller to the aircraft.
(Settings > Controller > Pairing)
Evolve User Manual V1.0 by XDynamics Limited 43