Disarming The Aircraft; Auto Take Off - XDynamics EVOLVE User Manual

DISARMING THE AIRCRAFT

After a landing the aircraft, hold the throttle stick down and to the left to disarm the motors. The LED indicators will
change color followed by a long beep and propellers will stop spinning. Make sure all the LED indicators are solidly lit by
the same color (either Green or Blue) with no blinking before moving the sticks back to central position. If the LEDs are
blinking the aircraft is still in arming mode, keep the sticks in the same position until all the LEDs are solid (either Green or
Blue).
(Left) (Right)
Ensure the aircraft is fully disarmed (either solid Green or Blue LED) before returning the left thumb stick to the
middle position.
64
OR
Push the left throttle stick down and to the left and wait for
the LED's light change. During disarming the LEDs color
will fast blink rapidly with different colors followed by a
long beep, the motors will then engage and the propellers
will start spinning. Move the throttle stick to the middle
position and the aircraft is ready to take off manually.

AUTO TAKE OFF

For ease of operation and to assist beginner operators, the evolve aircraft can take off and land automatically.
Follow the steps below:
1. Short Press and Long Press the Auto Take Off button for 3 seconds.
2. The aircraft will arm itself and take off.
3. The aircraft will rise to 4 to 5 feet. ( If the aircraft is in GPS mode it will hold position until the operator takes over, but
if it is in manual mode the operators needs to correct the altitude to prevent drifting.)
Follow the previous pre-flight check, as stated in arming the aircraft above.
Evolve User Manual V1.0 by XDynamics Limited 65