Pacific energy Alderlea T5 LE Insert Installation And Operating Instructions Manual page 23

Loosen ash lip bolts
Figure 23: Ash lip bolts.
4. Loosen the two bolts that secure the ash lip to the firebox (Figure 23), carefully lift up the ash lip and
remove from the firebox.
5. Loosen the screws on the wire support tabs and turn to remove the wires (Figure 24).
Remove screws
Figure 25: Speed control assy removal.
6. Remove the two screws securing the speed controls assembly to the ash lip (Figure 25). Remove cover
plate on opposite side.
7. Remove the control assembly from the ashlip bracket on the right hand side. Flip it over and reattach on
the left hand side of the ashlip (Figure 26). Use the upper screw holes for best alignment.
8. Route cable from speed control to fan and reattach wire support tabs on the underside of the ash lip. Note
wire positions (Figure 27 and Figure 28).
Reconnect wire clips
Figure 27: Reconnect wire support clips.
ALT5 LE Insert 230819-32
Remove screws and clips
Figure 24: Remove speed control screws and clips.
Speed
control assy
Figure 26: Relocating speed control assy and bracket.
Figure 28: Note wire position.
23
Ash lip
bracket
100003038