Direct Flue Connection (Permitted Only In The Usa) - Pacific energy Alderlea T5 LE Insert Installation And Operating Instructions Manual

Direct Flue Connection (permitted only in the USA)

Pacific Energy highly recommends the use of a full liner as the safest installation and providing optimum per-
formance. When connected to a full liner, the Insert is able to draft correctly and will prevent problems such
as difficult start-ups and smoking out the door.
Note: A clean-out door may be required under local codes, when a direct flue connection is used. Consult
local codes. A seal must be provided in the chimney throat
1. Measure from the first chimney flue liner tile to the top of the Insert. Allow extra length of liner to insert
into flue tile.
2. Feed the stainless steel liner through the damper area and into the first chimney flue tile. Attach a "stove
to liner" adapter to the bottom of the liner as per the liner manufacturer's instructions. Seal around where
the liner passes thru in the Chimney Throat.
3. Follow steps 3-9 on the previous page.
6" Stainless Steel
Rigid or Flex Liner
Flex Liner
Connector
Figure 8: Insert LE direct flue connection.
ALT5 LE Insert 230819-32
Figure 7: Direct flue connection.
17
Chimney
Flue tile
Liner
Throat seal
100003038