End Wall Prep - KidKraft Summerhill F29050 Installation And Operating Instructions Manual

Step 3: End Wall Prep
Part 1
It is important to assemble the frame on a flat, smooth surface.
A: Place (2768) Panel Floor and 2 (2769) Panel BT Frames on a hard, flat surface with the long side up. Tap in
2 (TN1) T-nuts per board. (fig. 3.1)
B: Place (2771) End Post and (2770) End Post Left side by side with the grooves facing up and in. (2770) End
Post Left on the right hand side. Place (2769) Panel BT Frames in the top and bottom grooves and (2768) Panel
Floor in the middle grooves. (fig. 3.2).
C: Make sure assembly is square then attach with 4 (S30) #8 x 1-1/16" Wood Screws per board. (fig. 3.2)
Fig. 3.1
TN1
2769
Fig. 3.2
Top
Flush
2771
Wood Parts
1 x Panel Floor 31.8 x 76.2 x 1066.8mm
2768
2 x Panel BT Frame 31.8 x 76.2 x 1066.8mm
2769
1 x End Post 31.8 x 63.5 x 2209.8 mm
2771
1 x End Post Left 31.8 x 63.5 x 2209.8 mm
2770
TN1
S30
x 4
2769
2768
Flush
12 x
6 x
2768
S30
Flush
Hardware
#8 x 1-1/16" Wood Screw
S30
1/4" T-nut
TN1
19
TN1
x 4
2770
2769
2769
S30
x 4
Bottom