KidKraft Summerhill F29050 Installation And Operating Instructions Manual page 45

Step 19: Gable End Assembly
Part 2
D: From the peak of the gable assembly measure approximately 3" (80.37mm) down and attach 1 (2843) Gable
Board C using 4 (S2) #8 x 1-1/2" Wood Screws as shown in (fig. 52.3 and 52.4). There should be maintaining
a 1" (25.40mm) space between the sides of Gable Board C and the edge of the Gable Assembly. (fig. 19.3 and
19.4)
E: Place (2841 and 2842) Gable Boards A and B on each side of the Gable assembly as shown in (fig. 19.3),
again making sure that there is a space of 1" (25.40mm) between the boards and the edge of the gable and
attach using 4 (S2) #8 x 1-1/2" per board. (fig. 19.3 and 19.4)
Fig. 19.3
Build 4 Gable Assemblies
2841
20X #8 x 1-3/8" Wood Screw
Build 4 Gable Assemblies
Wood Parts
8 x Gable Board A 15.9 x 108 x 169.3mm
2841
8 x Gable Board B 15.9 x 108 x 277.2mm
2842
4 x Gable Board C 15.9 x 108 x 304.8mm
2843
S2
x 4 per board
2843
Gable Board C
2842
2X Gable Board B
2X Gable Board A
Fig. 19.4
Gable Board C
2841
2X Gable Board B
2X Gable Board A
Hardware
80 x #8 x 1-1/2" Wood Screw
S2
2841
2843
2842
45
2842
2841