KidKraft Summerhill F29050 Installation And Operating Instructions Manual page 23

Step 4: Frame Assembly
Part 3
C: Loosely attach 1 (2607) Diagonal to (2606) SW Ground with 1 (H10) 1/4 x 2-1/4" Hex Bolt (with lock washer,
flat washer and t-nut). (fig.4.6)
D: Place (2606) SW Ground against the front right side of the (2627) SW Wall Panel making sure that the (2607)
Diagonal lines up with the edge of the panel as shown in fig. 4.5 and attach (2606) SW Ground to fort using 2
(S11) #8 x 2" Wood Screws and 1 (S4) #8 x 3" Wood Screw. (fig. 4.5)
E: Make sure that the (2607) Diagonal is tight to the edge of the (2627) SW Wall Panel then pre-drill pilot holes
with a 3/16" (4.8 mm) drill bit. Attach (2607) Diagonal to the (2627) SW Wall Panel with 1 (LS3) 1/4 x 3" Lag
Screw (with flat washer) checking that it remains flush to outside edge. (fig. 4.5 and 4.7)
F: Tighten Hex Bolt installed in step C:.
G: Repeat steps C: through F: to install an opposite assembly on the left side.
Flush
Fig. 4.5
2607
2606
S4
Fig. 4.7
FW1
LS3
2607
Wood Parts
2 x Diagonal 31.8 x 76.2 x 558.8mm
2607
2 x SW Ground 23.8 x 82.6 x 362 mm
2606
S11
Swing Wall
2 x
H10
2 x
LS3
4 x
S11
2 x
S4
S11
S4
Swing Wall
Hardware
1/4 x 2-1/4" Hex Bolt (lock washer, flat washer, t-nut)
1/4 x 3" Lag Screw (flat washer)
#8 x 2" Wood Screw
#8 x 3" Wood Screw
23
Fig. 4.6
LW1
H10
FW1
Flush
2607
LS3
FW1
2607
2607
T-Nut
2606