KidKraft Summerhill F29050 Installation And Operating Instructions Manual page 22

Step 4: Frame Assembly
Part 2
B: Place End Wall from Step 3 between the Front Wall and Back Wall noticing the wall orientation. The tops
and bottoms of the walls should be flush. Make sure the walls are square then using the pilot holes as a guide
predrill with a 3/16" (4.8 mm) drill bit and fasten the Back Wall to the End Wall and End Wall to the Front Wall
with 4 (WL5) 1/4 x 2-1/2" Wafer Lags per side. (fig. 4.4)
Fig. 4.4
WL5
Notice Back Wall
overlaps End Wall
Back Wall
End Wall
8 x
Front Wall
Hardware
1/4 x 2-1/2" Wafer Lag
WL5
22
Swing Wall
Notice End Wall
overlaps Front Wall