Stabilization Failed; Self-Test Failed - MES SQA-V Gold User Manual

User Guide Version 2.60 I-button WHO 5th
Error and
SECTION 10: Error Messages, Warning Messages and General
Warning
Warning
Messages
General Warning:

Stabilization Failed:

Self-test Failed:

Revision 21_Sep_2015

The SQA-V equipment's built-in protection for the operator and the
environment is ONLY operational if the SQA-V is operated properly following
the manufacturer's specifications.

CAUTION: There is a risk of explosion or shorting if the SQA-V battery is
replaced by an incorrect type. Replacement batteries MUST be the same type
and manufacturer. Dispose of used batteries in accordance with the
manufacturer instructions.

Environmental condition for storage and transport: Recommended to store the
SQA-V at temperatures between 20°C -30°C.

Ensure there is no testing capillary in the measurement compartment.

Remove the SQA-V from sources of electronic noise and vibrations.

Clean measurement compartment (refer to Appendix).

Reboot the SQA-V without a testing capillary in the chamber:

Turn system OFF then back ON at the main switch on the rear panel.

Press the front panel ON/OFF key to begin Auto-Calibration/Stabilization.

Call technical support if failure recurs.

Ensure there is no testing capillary in the measurement compartment.

Remove the SQA-V from sources of electronic noise and vibrations.

Clean measurement compartment (refer to Appendix).

Reboot the SQA-V without a testing capillary in the chamber:

Turn the system OFF then back ON at the main switch on the rear panel.

Press the front panel ON/OFF key to begin Auto-Calibration/Stabilization.
29