Toyota UH9000S Fitting Instructions Manual page 9

Fitting Instructions
UH9000S / UH9060S / UH9080S
Alternate antenna cable entry point
Remove the grommet from the firewall:
9.
a. Drill a 5 mm hole through the centre.
b. Refit the grommet to the firewall opening.
Pass a lead wire through the cut firewall grommet
c.
opening to the passenger's side footwell.
d. Attach the antenna cable to the lead wire.
10. Carefully pull the lead wire and antenna cable through
from the passenger's side footwell.
IMPORTANT
Use silicon spray to allow the antenna cable to pass
through the grommet more easily.
11. At the completion of the installation process seal the
antenna cable grommet entry point with an automotive
grade sealant and secure with a cable tie.
UH9000S
12. Disconnect the lead wire and route the antenna cable
below the footwell carpet line, behind the centre console
towards the driver's side footwell.
13. Pull the antenna cable through to the driver's footwell.
Page 9 of 16