Toyota UH9000S Fitting Instructions Manual page 10

UH9060S / 9080S
14. Disconnect the lead wire and pull the antenna cable into
the passenger's side footwell.
Power Lead Patch Harness - UH9000S
1. Route the power lead patch harness from the driver's side
footwell, behind the bottom edge of the console box
assembly to the rear power socket connector.
2. Disconnect the rear power socket connector and dehouse
the (2) connector pins from the rear power socket
connector [1].
3. House the (2) removed pins in the free power lead patch
harness connector [2].
4. House the (2) free power lead patch harness pins into the
existing rear power socket connector [3].
5. Connect the existing rear power socket connector to the
rear power socket [4].
IMPORTANT
6. Refer to the following diagram for wiring details
1
Existing vehicle
harness
3
Existing vehicle
Power lead
harness
patch harness
PRADO
Power
Existing vehicle power
socket
socket connector
2
1
Existing vehicle power
socket connector
2
1
To UHF CB
transceiver
Page 10 of 16
UH9000S / UH9060S / UH9080S
2
Existing vehicle Power lead
harness patch harness
4
Power lead
patch harness
Fitting Instructions
To UHF CB
transceiver
Existing vehicle power Power
socket connector socket
2
1
To UHF CB
transceiver