Summary of Contents for Toyota Avensis 2006 TNS600
Page 1
Avensis TNS600 RHD installation instructions Model year: 2006 Vehicle code: **T25*R-*****W Part number: • Navigation System PZ 445-00331-00 • Audio Frame 55405-05160 Manual ref. n : AIM 000 766-1...
Page 2
Avensis (T25) TNS 600 PRECAUTIONS PLEASE READ THOROUGHLY THESE PRECAUTIONS BEFORE THE INSTALLATION • Protect your car with fender cov- • Be sure to disconnect the negative ers, seat and so on. (-) lead from the battery terminals. • Use the correct tool when tight- •...
PWR•VOL VOICE NAVIGATION TUNE SEEK TRACK MENU DEST INFO VOICE AUDIO DISPLAY TILT OPEN TOYOTA B-9001 Description TNS600 WIRE HARNESS GPS ANTENNA NAVIGATION DISC WIRE CLAMP FOAM TAPE 2 + 3 WIRE TIE EARTH PLATE 01-07 Avensis (RHD) - 4...
Page 5
Avensis (T25) Avensis (T25) TNS 600 TNS 600 COMPONENT PARTS 55405-05160 OWNER’S MANUAL To be ordered separately. Refer to ATA database for partnumbers Avensis (RHD) - 5 01-07...
Avensis (T25) TNS 600 VEHICLE DISASSEMBLY FOR M/T MODELS Remove the gear lever knob FOR ALL MODELS b) Remove the gear lever hole cover : Clip (4x) Fig. 1 Remove the instrument panel cluster moulding : Clip (5x) Fig. 2 Remove the heater control assembly : Bolt (4x) Fig.
Avensis (T25) TNS 600 INSTALLATION OF THE GPS-ANTENNA Cut the foam (d) into 12 pieces as shown in the illustration. Fig. 5 Remove the release paper of the earth plate and attach the butyl tape shown. b) Apply the tapes to the adhesive side of the earth plate Fig.
Avensis (T25) TNS 600 WIRE HARNESS INSTALLATION CONNECTING PROCEDURES OF Splicing connector SPLICING CONNECTOR Pliers Remove the vinyl tube or wrapping tape from the length of vehicle wire harness to be connected. b) Insert the vehicle wire harness to beconnected securely into the guide slit.
Page 13
Avensis (T25) TNS 600 Cut the red/white wire away isolate Fig. 12 FOR VEHICLES WITHOUT PRE-WIRE Route the reverse sensor wire shown in the illustration. 10P (white) 20P (white) Fig. 13 Connect speed sensor wire (Violet/White) to terminal 3 of the 20P (white) 20P Wire side vieuw 20P (White) connector.
Page 14
Avensis (T25) TNS 600 Route the reverse sensor wire Recerse sensor wire shown in the illustration. b) Disconnect the 18P (White) connector. 18P (white) Fig. 15 Connect the reverse sensor wire (Green) to terminal 8 f the 18P (White) con- 18P Wire side vieuw 18P (white) nector.
Page 15
Avensis (T25) TNS 600 Secure the excess speed sensor wire Recerse sensor wire and reverse sensor wire as shown in Speed sensor wire the illustration using the foam tape Foam tape x 2 Fig. 18 Remove the speed signal from 20 pin connector (pin 3) Fig.
Page 16
Avensis (T25) TNS 600 Slight the airco to the left to disassem- le the airco. PWR•VOL SEEK TRACK DUAL TEMP Fig. 21 Slight (put) the frame on the airco and mount the brackets on the TNS600 and the airco. b) Connect the connectors and place the headunit back in place.
Page 17
Avensis (T25) TNS 600 12. Re fit all parts. AUTO DUAL TEMP TEMP Fig. 24 ENSURE THAT ALL REMOVED CONNECTORS ARE PUT BACK CORRECTLY. REFIT THE TRIM AND REMOVED PARTS. Avensis (RHD) - 17 01-07...
Manual, and confirm that the sound from the speakers changes. 4. Perform the “auto-compensation” procedure by following the section on “When Tires are Replaced” in the TNS600 Owner’s Manual. When an abnormality is suspected, perform troubleshooting based on the “Toyota Genuine Navigation System Service Manual”. REASSEMBLING Return all vehicle parts that have been removed to their original locations.