Toyota UH9000S Fitting Instructions Manual page 5

Fitting Instructions
UH9000S / UH9060S / UH9080S
Cut the outer tang off the firewall grommet where
8.
indicated.
Note: Refer to the Alternate antenna cable entry point
on page 9 if both grommet entry points are being
used..
Removal - Interior
Using a taped flat blade screwdriver remove the front
1.
passenger's side scuff plate (4 clips [ ], 10 claws and 2
guides).
Prise off carefully at retaining clip locations to avoid
damaging the clips and plate.
2. Remove the front passenger's cowl side trim board
(1 push-in clip and 2 clips [ ])
Prise off carefully at retaining clip locations to avoid
damaging the clips and panel.
3. Remove the front passenger's side instrument panel under
cover sub-assembly.
Remove (1) screw, unclip (3 [ ]), lower and pull away from
firewall.
Page 5 of 16