Toyota UH9000S Fitting Instructions Manual page 12

2. Disconnect the rear power socket connector and dehouse
the (2) connector pins from the rear power socket
connector [1].
3. House the (2) removed pins in the free patch harness
connector [2].
4. House the (2) free patch harness pins into the original rear
power socket connector [3].
5. Connect the original rear power socket connector to the
rear power socket [4].
IMPORTANT
Refer to the diagram on page 10 for wiring details.
UHF CB Transceiver Cradle and Radio
UH9000S
1. Using a suitable primer clean the console box at the cradle
mounting location.
2. Fit the UHF CB transceiver cradle to the console box
assembly as shown using the double sided tape provided.
Trim double sided tape to suit.
3. Carefully drill (2) 1.5 mm pilot holes at the mounting
locations shown.
WARNING
To avoid damage use a 10 mm drill stop.
4. Secure the cradle using (2) self tapping screws.
WARNING
Fitting the UHF CB transceiver cradle and radio in this
location will interfere with the full range of seat movement.
If the indicated location is not suitable, do not install the
UHF CB transceiver cradle and radio in a location that may
interfere with the operation and deployment of the SRS
airbags or seatbelt pretensioners, including driver, front
passenger and knee SRS airbags if fitted. Doing so may
result in serious injury or death.
5. Assemble the (2) slide mount brackets to the UHF CB
transceiver using the (2) screws supplied.
UH9000S / UH9060S / UH9080S
Page 12 of 16
Fitting Instructions