Toyota UH9000S Fitting Instructions Manual page 16

COMPLETION
IMPORTANT
1. Ensure the interior wiring and any excess antenna cable
is positioned to avoid fouling and rattling (cable tie as
required at a minimum of every 200 mm. Use self-adhesive
cable tie mounting blocks where necessary).
2. From the engine bay side, seal the antenna cable grommet
entry point with an automotive grade sealant and secure
with a cable tie.
3. Neatly cable tie the antenna cable to the existing engine
bay wiring harness where indicated to avoid fouling,
rattling or a possible rubbing condition.
Refit all remaining interior and exterior parts previously
4.
removed.
5. Check UHF CB transceiver operation.
UH9000S / UH9060S / UH9080S
Page 16 of 16
Fitting Instructions