Toyota UH9000S Fitting Instructions Manual page 8

3. Follow the existing wiring harness passing the antenna
cable through the (2) existing wiring harness clips.
4. At the completion of the installation, cable tie the antenna
harness to the existing wiring harness where indicated [ ].
5. Route the antenna cable between the fuse and relay
box and the inner quarter panel, through the existing clip
and below the fuel filter assembly (if fitted) and mounting
bracket.
6. At the completion of the installation, cable tie the antenna
cable to the existing wiring harness where indicated [ ].
Follow the existing wiring harness to the firewall grommet.
7.
8. At the completion of the installation, cable tie the antenna
cable to the existing wiring harness where indicated [ ].
Pass a lead wire through the cut firewall grommet opening
9.
to the passenger's side footwell.
Attach the antenna cable to the lead wire.
UH9000S / UH9060S / UH9080S
Page 8 of 16
Fitting Instructions