Toyota UH9000S Fitting Instructions Manual page 14

3. Slide the UHF CB transceiver into the cradle and connect
the power lead patch harness.
4. Fit the antenna adapter (supplied) to the antenna cable
and connect to the UHF CB transceiver.
5. Connect the speaker microphone extension cable to the
UHF CB transceiver and route behind the carpet line,
behind the centre console to the driver's side footwell.
6. Position the connector below the driver's side front console
box insert as shown.
7. Neatly cable tie the excess antenna cable, speaker
microphone extension cable and power cable to avoid
rattling and fouling. Use self-adhesive cable tie mount
blocks where necessary.
Refit the front passenger's side instrument panel under
8.
cover sub-assembly - (1) screw and (3 [ ])clips.
Speaker Microphone Hanger
1. Using a suitable primer clean the instrument panel at the
hanger mounting location.
2. Assemble the (2) halves of the speaker microphone
hanger using the (2) nuts and screws supplied.
3. Secure the microphone hanger to the driver's side lower
instrument panel pad sub-assembly in the position shown
using double sided tape provided. Trim double sided tape
to suit.
UH9000S / UH9060S / UH9080S
Page 14 of 16
Fitting Instructions