Change Data Format For A Single Scan - Newland NLS-FM420-MS-30 Integration Manual

Data Formatter

Change Data Format for a Single Scan

You can switch between data formats for a single scan. The next barcode is
scanned using the data format selected here, then reverts to the format you have
selected above. For example, you may have set your engine to the data format
you saved as Format_3. You can switch to Format_1 for a single trigger pull by
scanning the Single Scan – Format_1 barcode below. The next barcode that is
scanned uses Format_1, then reverts back to Format_3.
Note: This setting will be lost by removing power from the engine, or turning off/
rebooting the device.
Single Scan – Format_0
【Pro CMD：0323050】
Single Scan – Format_2
【Pro CMD：0323052】
nlscan.com
Single Scan – Format_1
【Pro CMD：0323051】
Single Scan – Format_3
【Pro CMD：0323053】
Tools
Code Programming ON
Code Programming OFF
Page 156