Change Data Format For A Single Scan - Newland HR11+ Aringa User Manual

** Enter Setup

Change Data Format for a Single Scan

You can switch between data formats for a single scan. The next barcode is scanned using the data
format selected here, then reverts to the format you have selected above. This setting is valid only when
the Multiple Data Formats feature is turned off.
For example, you may have set your scanner to use the data format you saved as Format_3. You can
switch to Format_1 for a single trigger pull by scanning the Single Scan – Format_1 barcode below. The
next barcode that is scanned uses Format_1, then reverts back to Format_3.
Note: This setting will be lost by removing power from the scanner, or turning off/ rebooting the device.
Single Scan – Format_0
Single Scan – Format_2
Exit Setup
Single Scan – Format_1
Single Scan – Format_3
144