Installing Memory; Dimm Installation; Removing Memory Modules - Supero SUPERSERVER 1028R-WMR User Manual

SUPERSERVER 1028R-WMR(T) User's Manual
5-5

Installing Memory

Caution: Exercise extreme care when installing or removing DIMM modules to
prevent damage.
Note: Check the Supermicro website for recommended memory modules. Modules
of the same size and speed are recommended.

DIMM Installation

1. Insert the desired number of DIMMs
into the memory slots, starting with
DIMMA1 (see the next page for the
location). For best performance,
please use the memory modules
of the same type and speed in the
same bank.
2. Push the release tabs outwards
on both ends of the DIMM slot to
unlock it.
3. Align the key of the DIMM module
with the receptive point on the
memory slot.
4. Align the notches on both ends of
the module against the receptive
points on the ends of the slot.
5. Use two thumbs together to press
the notches on both ends of the
module straight down into the slot
until the module snaps into place.
6. Press the release tabs to the lock
positions to secure the DIMM
module into the slot.

Removing Memory Modules

Reverse the steps above to remove the
DIMM modules from the serverboard.
P1_NVME1
BMC
P1_NVME0
JI2C1
BIOS
JVRM2
1
JBT1
PCH
JP1
JL1
JF1
LED2
Release Tabs
straight down into the
5-8
LAN2 LAN1 USB2/3 USB0/1
UID-SW
VGA
LAN CTRL
IPMI_LAN
X10DRW-E/T/N/NT
Rev. 1.01
CPU2
BAR CODE
BIOS
LICENSE
CPU1
JVR1
Notches
Press both notches
memory slot.