To Install The Hard Drive - Avaya CallPilot 703t Maintenance And Diagnostics

11. If you are replacing an existing hard drive, remove the old drive from the drive carrier
12. Position the new drive component-side down inside the drive carrier, and then attach
13. Continue with

To install the hard drive

Important:
The last bay must remain empty to ensure proper system cooling.
1. Slide the hard drive and drive carrier assembly (with the exposed drive facing up)
2. If not already done: Temporarily remove the front system fans from their slots in the
3. Connect the hard drive SCSI cable as follows (the end of the cable with two
Avaya CallPilot® 703t Server Maintenance and Diagnostics
as follows:
a. Remove the four screws that attach the drive to the carrier.
b. Lift the carrier off of the hard drive.
c. Place the drive in an antistatic protective wrapper.
the four screws that you removed earlier.
Ensure that the connectors on the back of the drive are flush with the rear of the
drive carrier.
To install the hard drive
into the server bay.
Important:
To provide more space inside the server so that you can connect the cables, do
not push the drive all the way in (that is, until it clicks into place).
bottom fan holder foam.
Do not disconnect the fans' power cables.
connectors is the hard drive end):
a. Ensure that a terminator is connected to the last connector at the hard
drive end of the cable.
b. Connect the second connector on the cable to the hard drive.
Place one hand on the front of the hard drive to hold it in place while you
connect the cable with the other hand.
Caution:
Risk of connector pin damage
on page 111.
To install the hard drive
December 2010 111