2-Channel Configuration Mono With Switching Option - Silicon Graphics Reality Center Installation Manual

Configurations

2-channel configuration mono with switching option

Principle drawing
TBDÃH‚v‡‚…
21<;
8uhryÃ

8uhryÃ

Cabling diagram RACK system - Projectors - ONYX
All source connections to the projector are done to port 4/5 (see RGB analog connection in chapter Connections or to 'Connection
Magic interface - Projector' page 8.2).
See next page for a cable diagram and an overview table.
The connections between the ONYX and the RACK system has to be done for each channel with a series connection of cable type
3 and 9 to input 1 of each RCVDS (most left module).
The external monitor which can display any channel must be connected with a series connection of Cable type 2 and 4 using BNC-
BNC coupling pieces to the Quad Switcher.
Cable type 1, RS232 connection between the projectors (RS232 out to RS232 in next projector) has to be installed even when there
is no RS232 connection with other equipement.
With a Cable type 10, the output RS232 of channel 0 projector has to connected to the RS232 input of the Quad Switcher.
The output RS232 of the VSE40 has to be connected to the input RS232 of the channel 2 projector using a cable type 10.
The RS232 output of the ONYX has to be connected to the RS232 input of the VSE 20/40 using a cable type 10.
8-18
8hiyrÇ’ƒrÃ#
ÃphiyrÇ’ƒrÃ!
S68FÆ’†‡r€
8hiyrÇ’ƒrÃ"ÃÃ8hiyrÇ’ƒrÃ(
8hiyrÇ’ƒrÃ"ÃÃ
8hiyrÇ’ƒrÃ(
RˆhqÃTƒyv‡‡r…
WT@Ã!#

RˆhqÃTv‡pur…

S8W9T$

S8W9T$

RˆhqÃTƒyv‡‡r…

8uhryà 8uhryÃ
8hiyrÇ’ƒrà 
8hiyrÇ’ƒrÃ
F
J L
0 D

8hiyrÇ’ƒrÃ!
F
J L 8hiyrÇ’ƒrà 
0 D

8hiyrÇ’ƒrÃ!
8hiyrÇ’ƒrà 
8hiyrÇ’ƒrÃ#
ÃphiyrÇ’ƒrÃ!

VƒÃ‡‚Ã%Évqr‚Æ‚ˆ…pr†
8hiyrÇ’ƒrà 
R5976280 RC3300W 19072001
8hiyrÇ’ƒrà