How To Select Crt Run In Cycle; Projector Warm Up - Silicon Graphics Reality Center Installation Manual

Service Mode

How to select CRT run in cycle ?

ENTER
SERVICE MODE
DYNAMIC ASTIGMATISM
G2 ADJUSTMENT
GAMMA CORRECTIONS
CRT RUN IN CYCLE

PROJECTOR WARM UP

CRT DRIVE MODE
BLOCK MODE: USER
MORE ...
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Projector warm up
What can be done ?
EXIT
EXIT
EXIT
How to select ?
ENTER
ENTER
SERVICE MODE
DYNAMIC ASTIGMATISM
G2 ADJUSTMENT
GAMMA CORRECTIONS
CRT RUN IN CYCLE
PROJECTOR WARM UP
CRT DRIVE MODE
BLOCK MODE: USER
MORE ...
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
é ê
CRT RUN IN CYCLE
A flashing white pattern will be
generated until <EXIT> is pressed.
The projector only uses memory
blocks adjusted on an internal
# pattern; if no such block is
available, the projector can't run
the procedure and leaves the
adjusment mode.
<ENTER> to continue
<EXIT> to cancel
menu 2
é ê
PROJECTOR WARM UP
OPTION : ON
A FULL WHITE PATTERN
WILL BE GENERATED FOR
20 MINUTES AT POWER UP
AFTER THIS PROCEDURE
THE PROJECTOR IS READY
TO PERFORM IN OPTIMUM
CONDITION
TOGGLE OPTION ON OR OFF
with <ENTER>
<EXIT> to return
menu 2