Table of Contents
Advertisement
Note
For more information about terminal assignments, see the circuit manual of the drive.
Note
You can find a list and description of the feedback signals of the circuit-breaker in the
commissioning manual of the drive.
6.5.8
Connecting the encoder to the SMC30 Sensor Module
Safety instructions
NOTICE
Damage caused by incorrectly connected external encoder
If the external encoder is not connected or operated correctly, this can damage the
components.
● Only one measuring system can be connected to each sensor module. The sensor module
Procedure
1. Carefully comply with the 5 safety rules.
2. Allow unimpeded access to the SMC30 Sensor Module.
3. Route the cables from the encoder into the cabinet from below and to the encoder module.
4. Connect the encoder cables
SINAMICS GM150 6SL3810-2LN31-8AA2
Operating Instructions Rev.201910281332 EXAMPLE
is wired internally to the customer terminal strip. For further information, see the circuit
manual.
①
to the SMC30 Sensor Module.
Electrical connection
6.5 Connection
91
Advertisement
Table of Contents
