Table of Contents
Advertisement
11.2.3
TRAKA TOUCH APPLICAT ION
For the Sagem MorphoSmart Fingerprint Reader to work with Traka Touch, the Traka Touch system must have Traka
Touch Application version 01.02.4256.41 (07-Sep-12) or later installed.
11.3
ACCESS METHODS
With the correct operating system version and application version installed, to activate the Sagem MorphoSmart
Fingerprint Reader you simply need to plug the reader in. There are no specific reader configuration options that need
to be set for the reader to work – it's simply plug & play.
In addition, it's possible to use a Keypad ID or a Card ID as an alternative method of access or a backup method of
access in case of issues with the fingerprint reader. For users to access the system via the alternative method the
associated user record must have a Keypad ID or Card ID defined.
Mode
No fingers enrolled
Fingers enrolled
In keypad-only mode, any user may opt out of using a fingerprint by not enrolling a template and by defining a Keypad
ID in their user record. The user will then be able to login using a normal Keypad ID. This is useful for users who have
poor fingerprints.
PIN functions as normal and the system will ask for it if the PIN is defined in the user record.
11.4
READER DISCONNECTION / RECONNECTION
If the Sagem MorphoSmart Fingerprint Reader is disconnected at any point, the system will revert back to the alternative
method of access (i.e. Keypad Only or Card Reader).
TIP:
It's worth setting up at least one administrator with a Keypad ID or Card ID so that they can still access the system
in case of reader issues.
At application start-up or whenever a (new) reader is attached to the system while the application is running, the
application will initialise the Reader and will send down all templates from the Traka Touch SQL CE Database to the
reader – this may take some time when there are a lot of users enrolled. A message will appear at the top of the display
saying 'Initialising Biometrics...' whilst this is in progress.
There is no need for any 'Sync' or 'Reset' function as the reader is updated dynamically as each user record is changed.
Fingerprint templates cannot be taken from one Traka Touch to another by moving the reader.
NOTE:
If the reader is disconnected whilst in the middle of identifying or enrolling a user, this will invalidate
the whole communication process and so if you try to reconnect the reader it will no longer work until you
power cycle the whole system.
11.5
HOW TO ENROL A USER
There are 2 ways of enrolling users' fingerprints on the Traka Touch system:
Manually enrolled by an admin
Via an Enrolment ID
V4.3 10/09/19
This Document is uncontrolled when printed unless over stamped "CONTROLLED DOCUMENT"
Keypad Only
Enter Keypad ID on keypad
Touch finger
Card Reader
Swipe Card
Touch finger OR Swipe Card
UD0090
Page 101 of 143
Advertisement
Table of Contents
