Danfoss VLT AQUA Drive Design Manual page 106

5. How to Install
Save Drive Settings:
1.
2.
3.
4.
All parameters are now stored on the PC.
Load Drive Settings:
1.
5
2.
3.
4.
5.
All parameter settings are now transferred to the drive.
A separate manual for MCT 10 Set-up software is available.
The MCT 10 Set-up Software Modules
The following modules are included in the software package:
106
Connect a PC to the unit via the USB com port.
Open MCT 10 Set-up software
Choose "Read from drive".
Choose "Save as".
Connect a PC to the unit via the USB com port.
Open MCT 10 Set-up software
Choose "Open"– stored files will be shown.
Open the appropriate file.
Choose "Write to drive."
MCT 10 Set-up Software
Setting parameters
Copy to and from adjustable frequency drives
Documentation and print-out of parameter settings incl. diagrams
Ext. User Interface
Preventive Maintenance Schedule
Clock settings
Timed Action Programming
Smart Logic Controller Set-up
Cascade Control Config. Tool
MG.20.N2.22 - VLT ® is a registered Danfoss trademark.
VLT ® AQUA Drive Design Guide