Danfoss VLT AQUA Drive Design Manual page 124
Hide thumbs
Also See for VLT AQUA Drive:
- Programming manual (298 pages) ,
- Design manual (228 pages) ,
- Instruction (206 pages)
Table of Contents
Advertisement
7. RS-485 Installation and Set-up
7.1: Network Terminal Connection
7.1.3. VLT AQUA Hardware Set-up
7
Use the terminator dip switch on the main
control board of the adjustable frequency
drive to terminate the RS-485 bus.
124
NOTE
The factory setting for the dip switch is OFF.
MG.20.N2.22 - VLT
Terminator Switch Factory Setting
®
is a registered Danfoss trademark.
VLT
®
AQUA Drive Design Guide
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the VLT AQUA Drive and is the answer not in the manual?