Dimming Mode Settings; Custom Programs; Auto Mode And Auto Speed - Blizzard Lighting Motif Fresco Series Manual

Dimming Mode Settings:

Allows users to set the fixture to use 1 of 4 (x2) dimming curve settings for smoother (and slower)
dimming capabilities. In the control panel menu, there are two settings for each curve that are
distinguishable from one another by the trailing dot.
Linear Curve
(LIN, LIN.)
DMX%
*The curve settings with the trailing dot adds a bit more delay to the curve for a smoother effect.
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to SET and press <ENTER>,
then <UP/DOWN> buttons again to scroll to DIM, and press the <ENTER> button.
2.) Now use the <UP/DOWN> buttons to highlight either LIN (Linear), SQR (Square), ISQR
(Inverse Square), SCUR (S-Curve), LIN. (Smooth Linear), SQR. (Smooth Square), ISQR.
(Smooth Inverse Square), or SCUR. (Smooth S-Curve), then hit <ENTER>.

Custom Programs:

Allows users to create up to 3 customizable, 20 scene programs.
Creating A Custom Program:
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to PROGRAM, and press
<ENTER>.
2.) Now use the <UP/DOWN> buttons to highlight your choice of either CHS1, CHS2, or
CHS3 and press <ENTER>.
3.) Start with editing scene 1 (SC01), customizing it to your liking by using the choices outlined
in the table below. You can insert any of its 5 built-in auto programs (AT01-AT05), and adjust
its speed (ATSP 0-255), and also set the duration (in seconds) before moving on to the next
scene (TIME 0-255). You can also add a fade in effect to the start of this scene (WAIT 0-255),
and/or strobe (SHUT 0-255). Finally, if you want to use this scene in your program, be sure to
enable it (USE: YES/NO).
4.) Repeat the above process to create up to 20 scenes in each of the 3 customizable programs.
R (0-255) - Red Intensity
G (0-255) - Green Intensity
B (0-255) - Blue Intensity
UV (0-255) - UV Intensity
SHUT (0-255) - Strobe (slow - fast)
Running A Custom Program:
1.) To view your newly created lighting masterpiece, use the <MENU> and <UP/DOWN>
buttons to navigate to AUTO, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight your choice of either CHS1, CHS2, or CHS3 and
press <ENTER>.

Auto Mode and Auto Speed:

Set single or Master/Slaved units to run in sound active or auto mode at user selectable speeds.
Auto Mode:
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to navigate to AUTO, and press
the <ENTER> button.
2.) Now use the <UP/DOWN> buttons to highlight any program ranging from AT01-AT05,
and press <ENTER>.
Motif Fresco™ User Manual Rev. B
Square Law Inverse Square Law
(SQR, SQR.)
DMX%
AUTO (AT01-AT05) - Auto Programs
ATSP (0-255) - Auto Speed (fast - slow)
TIME (0-255) - Scene Time (seconds)
WAIT (0-255) - Fade In (fast - slow)
USE (YES/NO) Use Scene in Program?
Page 12
(ISQR, ISQR.)
DMX%
If USE is set to NO, or TIME is set
to 0, the scene will not run!
S-Curve
(SCUR, SCUR.)
DMX%
IMPORTANT:
(c) 2016 Blizzard Lighting, LLC