Display Reverse; Display Off/On; Dmx Fail Settings; Dimming Mode Settings - Blizzard Lighting N-Trance Manual

Display Reverse:

1.) Navigate the main menu to reach Settings, and then press the <ENTER> button.
2.) Highlight Display Rev. and then press <ENTER>.
3.) Choose from ON (inverted 180°) or OFF, and press <ENTER> to confirm.
Display OFF/OFF:
1.) Navigate the main menu to Settings, and then press <ENTER>.
2.) Highlight Display and then press <ENTER>.
3.) Choose from Hold (continuous), or OFF (after 1 minute of inactivity). Press <ENTER> to confirm.

DMX Fail Settings:

1.) Navigate the main menu to Settings, and then press <ENTER>.
2.) Highlight DMX Fail and then press <ENTER>.
3.) Choose either Hold (holds last received signal), or Blackout. Press <ENTER> to confirm.

Dimming Mode Settings:

Use any 1 of 4 dimming curve settings for smoother (and slower) dimming capabilities.
Linear Curve Exponential Logarithmic S-Curve
(Linear) (Exp) (Log) (S Curve)
DMX% DMX% DMX% DMX%
1.) Navigate the main menu until you reach Settings, press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Dimmer Curve, and press <ENTER>.
3.) Now you can use the <UP/DOWN> buttons to highlight Linear, Exp (exponential), Log
(logarithmic), or S Curve. Press the <ENTER> button to confirm your selection.

Dimmer Response:

1.) Navigate the main menu until you reach Settings, press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Dimmer Response, and press <ENTER>.
3.) Now use the <UP/DOWN> buttons to highlight LED which the dimming responds abruptly to DMX
changes, or Halogen which is similar to that of a halogen lamp, with more gentle changes in brightness.
4.) Press <ENTER> to confirm your selection.

Pan/Tilt Reverse:

1.) Navigate the main menu until you reach Settings, press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Pan Rev or Tilt Rev, and press <ENTER>.
3.) Now use the <UP/DOWN> buttons to highlight OFF or ON, and press <ENTER> to confirm.

Pan Angle:

1.) Navigate the main menu until you reach Settings, press <ENTER>. Then use the <UP/DOWN>
buttons to highlight Pan Angle > 540 or 630 degrees, and press <ENTER> to confirm.

Calibrate:

1.) For fine calibration adjustments, navigate the main menu until you reach Settings, then press
<ENTER>. Now use the <UP/DOWN> buttons to highlight Calibrate then <ENTER>, and choose an
effect to adjust anywhere ranging from 0-255. When finished press <ENTER> to confirm.

Factory Reset:

1.) Navigate the main menu until you reach Settings, press <ENTER>. Then use the <UP/DOWN>
buttons to highlight Factory Reset > YES or NO (to cancel), and press <ENTER>.
Page 13
N-Trance™ User Manual - Rev. A (c) 2018 Blizzard Lighting, LLC