DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Select the Channel Mode
1.) Press <MENU> to enter EDIT interface.
2.) Use the <UP/DOWN> buttons to choose Chnd, press <ENTER>.
3.) Use the <UP/DOWN> buttons to highlight 14Ch or 23Ch.
4.) Press the <ENTER> to confirm, or <MENU> to exit.
Select the Starting DMX Address
1.) Press <MENU> to enter EDIT interface.
2.) Use the <UP/DOWN> buttons to choose Addr, press <ENTER>.
3.) Use the <UP/DOWN> buttons to choose a starting DMX address ranging from
001-512, press <ENTER> to confirm, or <MENU> to exit.
Master/Slave Mode Settings
1.) Connect fixtures together via DMX.
2.) Press <MENU> to enter EDIT interface.
3.) Use the <UP/DOWN> buttons to choose SLnd, press <ENTER>.
4.) Use the <UP/DOWN> buttons to choose Mast (master) or SL1 (slave), and
press <ENTER>.
Auto and Sound Active Modes:
*Important:
To use Auto or Sound Active scene modes (Shnd 1-3) in Standalone, the
settings in DMX Lost must also be set to match: Auto or Soun. Press <MENU>, then
navigate to Lost, select Auto or Soun and save. Then...
Auto Mode
1.) Press <MENU> to enter EDIT interface.
2.) Use the <UP/DOWN> buttons to choose Shnd, press <ENTER>.
3.) Use the <UP/DOWN> buttons to choose Sh1, Sh2 or Sh3, press <ENTER>.
Sound Active Mode
1.) Press <MENU> to enter EDIT interface.
2.) Use the <UP/DOWN> buttons to choose Shnd, press <ENTER>.
3.) Use the <UP/DOWN> buttons to choose Sh1, Sh2 or Sh3, press <ENTER>.
4.) For mic sensitivity, navigate the main menu to Sens, press <ENTER>.
5.) Then use the <UP/DOWN> buttons to choose the microphone sensitivity level
ranging from 0% to 99%, and press <ENTER>.
Hypno™ Beam Manual Rev. A
Page 14
© 2017 Blizzard Lighting, LLC