Dmx Mode; Select The Channel Mode; Select The Dmx Starting Address; Master/Slave Mode Settings - Blizzard Lighting Blockhead Z9 Manual

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

Select the Channel Mode

1.) Navigate the main menu to reach ChanMod, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight 16CH, 22CH, or 50Ch.
3.) Press the <ENTER> button to confirm.
Select the Starting DMX Address
1.) Navigate the main menu to reach DmxAddr, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to choose a starting DMX address ranging from
001-512, and press the <ENTER> button to confirm.

Master/Slave Mode Settings

1.) Daisy chain fixtures DMX in/out, with the controller at the beginning.
2.) There is nothing else to it! The first fixture in the DMX chain is the master
fixture, and the following fixtures will follow the master.
Auto and Sound Active Modes:
Set single or Master/Slaved units to run in auto mode at user selectable speeds.

Auto Mode

1.) Navigate the main menu to reach WorkMod, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to choose Auto, press <ENTER>.

Sound Active Mode

1.) Navigate the main menu to reach WorkMod, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to choose Sound, press <ENTER>.
Mic Sensitivity
1.) Navigate the main menu to reach Tool, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to choose SundHig, press <ENTER>.
3.) Use the <UP/DOWN> buttons to choose the microphone sensitivity level
ranging from 0-16, then press the <ENTER> button to confirm.
Blockhead™ Z9 Manual Rev. A
Page 12
© 2016 Blizzard Lighting, LLC