NEC Express5800 Series Maintenance Manual page 94

Chapter 2 Configuring and Upgrading the System
94
The RAID device names assigned to internal disks
•
Important When the status of each disk becomes "resync" "recovery" "check" or "repair"
do not add a disk, insert/remove HDD, power off or restart the system. Wait until
the status indication of Raid device disappears and the status of each disks
become "in_sync". Check the status of RAID using the "esxcli storage mpm"
command, which is described later in this document.
•
Use only the hard disk drives specified by NEC. There is a risk of hard disk as
well as the entire device breakdown when you install a third-party hard disk
drive.
Purchase two, paired hard disk drive of the same model to configure the hard
drive redundancy. For information on which HDD suits this device the best, ask
your sales agent.
Express5800/R320c-E4, R320c-M4 Maintenance Guide (VMware)
2. Disk Operations