Chapter 1 Maintenance
4. Restart the PCI module.
If the PCI Module 0 was stopped in the step 3, run the following command and the PCI module will be
started.
# cd /opt/ft/bin
# ./ftsmaint bringup 10
Once the PCI module is started, PCI module diagnosis, mirror volume duplication and PCI module
duplication are performed.
The PCI module's status LED changes as shown below:
[Indications of status LED]
Immediately after the PCI module startup until the completion of diagnosis:
(1)
(2)
(3)
When duplication of disks is started after the completion of PCI module diagnosis:
(1)
(2)
(3)
After the completion of disk duplication and when the PCI modules are duplicated:
(1)
(2)
(3)
LED
PRIMARY LED
DISK ACCESS LED
LED
System FT LED
LED
PRIMARY LED
Amber or Green blinking
DISK ACCESS LED
(Green when accessing to
LED
System FT LED
LED
PRIMARY LED
DISK ACCESS LED
LED
System FT LED
Express5800/R320c-E4, R320c-M4 Maintenance Guide (VMware)
5. Checking the Duplicating Operation of Modules
Secondary*
-
Amber or Green blinking
-
(Green when accessing to
System
-
Secondary*
-
Amber or Green blinking
(Green when accessing to
HDD)
System
-
Secondary*
-
Green
System
Green
Primary*
Green
HDD)
Primary*
Green
HDD)
Primary*
Green
Green
39