Notes On Using Flash Fdd; Compensation For Recorded Data; Handling Flash Fdd; Use With Expressbuilder - NEC Express5800 Series Maintenance Manual

Chapter 3 Useful Features
4.1

Notes on Using Flash FDD

Flash FDD is only intended as a temporary means of recording a driver software, so do not use it to back up
data.

4.1.1 Compensation for recorded data

NEC will not pay compensation for data recorded on Flash FDD if the data is lost.

4.1.2 Handling Flash FDD

•
Flash FDD is consumables.
If Flash FDD causes an error, use a new Flash FDD.
•
Do not turn off the server while the access LED of Flash FDD is blinking.
Turning off the server at this time can cause a failure or data corruption.
•
Flash FDD cannot be connected via USB hub.
Directly connect Flash FDD to USB connector of the server.
•
Before handling Flash FDD, discharge static electricity from your body by touching a nearby metal object
(such as a doorknob or aluminum frame).
•
Do not disassemble Flash FDD.
•
Do not apply a strong force to Flash FDD.
•
Do not place Flash FDD in an area directly exposed to sunlight or near a heater.
•
Do not handle Flash FDD while eating, drinking, or smoking. Also, avoid contact with thinner, alcohol, or
other corrosive substances.
•
Carefully connect Flash FDD to the server.
•
Do not move the server while Flash FDD is connected to USB connector.
•
Remove Flash FDD from the server after use.

4.1.3 Use with EXPRESSBUILDER

•
Connect Flash FDD after Top Menu of
EXPRESSBUILDER appears.
•
Before you exit EXPRESSBUILDER, remove
Flash FDD from the server.
•
Click [Remove] in the lower right corner of
the menu to disable Flash FDD, and then
remove it.
186
Express5800/R320c-E4, R320c-M4 Maintenance Guide (VMware)
4. Flash FDD