Advertisement
Retractor bracket
Use the retractor bracket to mount retractors in the Cable
Cubby enclosure. The retractor bracket accommodates
up to three Retractor Series/2 or Retractor Series/2
XL cable retraction modules. The retractors must be
purchased separately.
If you require retractors, insert the retractor bracket as
shown in figure 5.
NOTE:
Do not mount the retractors in the retractor
bracket until after the Cable Cubby is mounted
(see
Install the Retractors
Install retractor filler modules (see www.extron.com) in
any unused retractor mounting spaces.
Optional retractor brackets (see www.extron.com) each
accommodate two cable retraction modules. These
brackets must be purchased separately. They are sold
in pairs and allow the cable retractors to be mounted at
the outer edges of the enclosure with one of the other
modules mounted centrally.
AAP module, cable pass-through module and power module
Insert the modules into the cable cubby as shown in
figure 6.
NOTE:
Extron recommends mounting the power
module on the left side of the enclosure.
AC power and AC+USB power modules are available
for US, Europe, and other major world markets. They
must be purchased separately (see www.extron.com).
Most AC power modules provide two unswitched AC
outlets.
The AC+USB power modules provide one or two AC
outlets and two USB power outlets.
WARNING: Risk of Electric Shock. To ensure
proper electrical grounding, use the
provided #6-32 mounting screws with the
star washers.
AVERTISSEMENT :
Risque de choc électrique.
Afin d'assurer une mise à la terre correcte,
utilisez les fixations de mise à la terre #6-32 et
les rondelles en étoile fournies.
on page 7).
Figure 5.
Figure 6.
Insert the bracket as shown.
The bracket may be installed on the
left or right side of the enclosure and
at the lowest height.
Install the Retractor Bracket
2
Install the Connectivity and Power Modules
Product Category
2
Se
Secure the bracket using four of
the
the provided pan-head mounting
screws with star washers. Tighten
the screws using a screwdriver.
1
1
Insert the modules
into the Cable Cubby.
Secure the modules using
four of the provided
pan-head mounting screws
and star washers.
5
Advertisement
