Table of Contents
Advertisement
GD1 – Installation Guide
2.2 – J1 CONNECTOR: THREE-PHASE 400 V POWER INPUT FOR THE CONFIGURATION WITH
EXTERNAL POWER SUPPLY UNIT (GDPS)
External power supply unit GDPS-400/cc
4 pins male with 10.16 mm pitch (female connector provided)
Tightening torque of the connector screws: 1.2 to 1.5 Nm
PIN
SIGNAL
1
Phase L1
2
Phase L2
3
Phase L3
4
GND
2.3 – J2 CONNECTOR: DC BUS FOR THE CONFIGURATION IN 400 V WITH EXTERNAL POWER
SUPPLY UNIT (GDPS)
2 pins male with 10.16 mm pitch (female connector provided)
Tightening torque of the connector screws: 1.2 to 1.5 Nm
2
Section: 2.5 mm
(AWG14) for GDPS-400/16.
2
Section: 6 mm
(AWG10) for GDPS-400/32.
600 V / 105°.
PIN
SIGNAL
1
DC+
2
DC-
The DC+/DC- polarity with the multiaxis power supply unit and between the drives MUST be
observed. Length max. = 200 mm.
2.4 – X6 CONNECTOR: EXTERNAL BRAKING RESISTOR
3 pins female screw connector with 7.5 mm pitch.
Tightening torque of the connector screws: 0.5 to 0.6 Nm.
2
Section: 2.5 mm
(AWG14).
600 V / 105°.
PIN
SIGNAL
1
RB
2
NC
3
RB
44
I/O
FUNCTION
I
I
Power input 400 V
I
Mains ground
I/O
FUNCTION
O
Parallel connection of the DC bus
O
Parallel connection of the DC bus
I/O
O
No connection polarity
O
External braking resistor type dp 33/280 (GDPS-400/16)
External braking resistor type E (GDPS-400/32)
O
Irms rated = max. 42 A
three-phase
AC
600 V / 105°. Section: 6 mm
(AWG10)
Connected to the X11 connector of
the drives
Connected to the X11 connector of
the drives
FUNCTION
Part 2 – Chapter 2 - Connectors
DESCRIPTION
2
DESCRIPTION
Advertisement
Table of Contents
