Table of Contents
Advertisement
GD1 – Installation Guide
1.6.2 – R
EFERENCE TO THE
According to the Directive 2004/108/EC, the GD1 drives have been approved with regard to their compliance with
the Electromagnetic Compatibility standards concerning the power servos referenced in the EN 61800-3 standard
"Electrical variable speed power servo systems", Part 3:
EMISSION
EN 61800-3:2004 – Part 3: Section 6, 4-2 (C3 class equipment – see tables 17 and 18)
IMMUNITY
EN 61000.4-2-3-4-5-6
Use: Second environment type including other places than those directly supplied by low voltage
mains.
NOTE: Industrial areas and technical rooms are an example of "second environment type".
Class of the drive equipment: C3.
Standard to be applied to the electrical equipment of industrial machines: EN 60204-1.
1.6.3 – R
EFERENCE TO THE
GD1 series drives have been "UL
This product was evaluated to:
♦
the Third Edition of UL508C, the UL Standard for Power Conversion Equipment, dated May 2002 for the
UL Listing (USL),
Providing that the manual is specifying that the end user has to provide an isolated power supply, for 24 V
auxiliary input protected by a 4 A UL Listed fuse, the power board is considered within a limited voltage/current
circuit per section 31.4 of UL508C. Therefore, spaces on the power board are not required to be evaluated per
section 31.2 of UL508C and were evaluated according to UL840.
Per UL 840 (Second Edition, dated May 20, 1993) requirements, spaces are limited to 2.5 mm assuming pollution
degree 2 environment.
1.7 – OTHER DOCUMENTS REQUIRED FOR THE COMMISSIONING
GD1 User
Guide,
Communication
protocol,
Programmation
Guide.
1.8 – OTHER DOCUMENTS REQUIRED FOR EXTENSION BOARDS
Encoder output "EO" manual,
Profibus manual,
Ethercat manual.
12
CE
STANDARDS
UL
STANDARDS
" listed according to UL508C and UL840 regarding the insulator.
US
Part 1 – Chapter 1 – General description
DC
Advertisement
Table of Contents
