Table of Contents
Advertisement
GD1 – Installation Guide
1 – OPERATING ENVIRONMENT CONDITIONS
A
-
CLIMATIC CONDITIONS
1
-
Cooling temperature
2
-
Room temperature
3
-
Relative moisture
4
-
Dust and particles
5
-
Operationless periods
B
-
MECHANICAL INSTALLATION CONDITIONS
The drive must be mounted indoor, on a stiff surface, in rooms or additional housings without hindering
the heatsink and the fan. The liability may be increased by installing a cooling system.
Other installation conditions must be specifically analysed and be subjected to a technical specification
agreed by INFRANOR.
Mechanical mounting
There are two possible mountings:
-
Normal mounting on the cabinet rear wall,
-
Wall-crossing fastening
over the fastening hooks. The advantage of this solution in the energy dissipation outside the
cabinet part where the electronics (control, PLC, etc.) are located.
Vibrations
Vibrations must remain within the limit values of the IEC 60721-3-3, class 3M1 standard for fixed
equipment.
Frequency (Hz)
2 ≤ f < 9
9 ≤ f < 200
Vibrations which exceed these limits or the use on mobile equipment are considered as unusual operating
conditions.
50
Air: 0°C to +40° C
+5°C to +40°C. As from 40°C, the peak currents
are reduced of 3% per °C
5% to 85% without condensation
Clean air (pollution degree 2)
Drive must be protected against conducting dust
< 1 year: no restrictions
> 1 year: re-format the power capacitors by
supplying the drive with a voltage ≤ 50% of the
drive rated voltage during 30 minutes
(see dimensions in section 2.2 of this
Amplitude (mm)
0.3
-
chapter), which requires to turn
2
Acceleration (m/s
-
1
Part 3 - Appendix
)
Advertisement
Table of Contents
