Table of Contents
Advertisement
GD1 – Installation Guide
3.12 –CONNECTOR X10: POWER – MOTOR OUTPUT
4 pins male (female connector provided).
7.62 mm pitch for current ratings ≤ 45 A.
10.16 mm pitch for current ratings > 45 A.
Tightening torque of the connector screws:
0.5 to 0.6 Nm for connectors with 7.62 mm pitch
1.2 to 1.5 Nm for connectors with 10.16 m pitch
PIN
SIGNAL
3
W
2
V
1
U
4
GND
3.13 – X11 CONNECTOR: POWER – DC BUS
2 pins male (female connector provided).
7.62 mm pitch for current ratings ≤ 45 A
10.16 mm pitch for current ratings > 45 A
Tightening torque of the connector screws:
0.5 to 0.6 Nm for connectors with 7.62 mm pitch
1.2 to 1.5 Nm for connectors with 10.16 mm pitch
Use a cable termination for 2 same section wires.
PIN
SIGNAL
I/O
1
DC+
I/O
2
DC-
I/O
.
The DC+/DC- polarity with the multiaxis power supply unit and between the drives MUST be
observed.
Max. length: 200 mm
IMPORTANT
The motor and brake cable must be shielded and connected over 360° on the cabinet rear wall, as near as
possible to the drives.
♦
The GND reference must be connected to the GND pins.
♦
Please use only copper conductors for the cable terminations.
♦
Torque value for the wiring terminations: this value must comply with the certified terminal block.
3.14 – X12 CONNECTOR: POWER SUPPLY INPUT (internal supply)
3.14.1 – S
-
INGLE
PHASE POWER INPUT CONNECTOR FOR THE
3 pins male with 7.62 mm pitch (female connector provided).
Tightening torque of the connector screws: 0.5 to 0.6 Nm
PIN
SIGNAL
1
Phase L1
2
Neutral
3
GND
28
I/O
FUNCTION
O
Motor phase W
O
Motor phase V
O
Motor phase U
Motor ground
FUNCTION
Parallel connection of the DC bus
Parallel connection of the DC bus
I/O
FUNCTION
I
Power input 230 V
I
Mains ground
GD1-uuu/05 to 20 A: section 1 mm
GD1-uuu/30 to 45 A: section 2.5 mm
GD1-uuu/60 and 90 A: section 6 mm
600 V / 105° shielded. Max. 25 m
GD1-uuu/05 to 45 A: section 2.5 mm
GD1-uuu/60 and 90 A: section 6 mm
600 V / 105°
230 V
SINGLE
AC
Irms rated = max. 10 A
single-phase
AC
600 V / 105°. Section: 1 mm
(AWG16)
Part 1 – Chapter 3 – Inputs-Outputs
DESCRIPTION
2
(AWG14)
2
(AWG10)
2
(AWG8)
DESCRIPTION
2
(AWG14)
2
(AWG10)
-
AXIS CONFIGURATION
DESCRIPTION
2
Advertisement
Table of Contents
