PerkinElmer Lambda 365 Fiber Coupling Module Installation Instructions Manual page 6

M easurem ent
System Self Test
The Fiber coupling module with fiber optic probe should be installed after System Self Test is finished.
NOTE:
Start the System Self Test after warming up the system for at least 20 minutes.
NOTE:
1. Install a single cell holder and base plate.
2. Double-click on the UV Express folder and select experiment mode for starting.
3. The following window will appear. Make sure that the sample compartment is closed firmly and
select OK.
4. Click OK after finishing the System Self Test.
6
09931262E