Icom MR-1220 Series Instruction Manual page 63

Settings for a maintenance
D Resetting to the defaults
When you reconfigure your settings, you can reset the
radar settings to the factory defaults.
There are 2 types of resetting. Select an appropriate
way, according to your situation.
• Settings Reset Resets settings other than in the
initial menu.
• Factory Reset Resets all the settings to the factory
defaults.
NOTE: You can reset the settings only in the
Standby mode.
1. Confirm the radar is in the Standby mode, if
necessary, push [TX (SAVe)]/[
the Standby mode.
2. Select "Settings Reset" or "Factory Reset" in the
initial menu.
[MenU]/[ ] > initial > Settings Reset
[MenU]/[ ] > initial > Factory Reset
3. Push [enTeR]/[ ].
• <OK> and <Cancel> are displayed.
4. Push [◄] to select <OK>, and then push [ENTER]/
[ ] to reset the settings.
• After Factory Reset has been done, the radar
automatically restarts and the initial screen as shown
below is displayed.
Select a language, and then push [enTeR]/
[ ] to boot up the radar.
L The selectable language differs, depending on the
display unit version.
] to enter
10
MAinTenAnCe
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
58